RCM BIT 391CB Uso Y Mantenimiento página 42

EN
6.1 CONTROL PANEL
(Fig. 8)
1) LEDs status of battery charge
(only for CB version)
This lights up when the button (3) is set
to "I" or "II", indicating the level of battery
charging.
- When the LED (1c) is illuminated, it in-
dicates that the battery charge status
is at maximum.
- When the LED (1b) is illuminated, it in-
dicates that the battery charge status
is at about half.
- When the LED (1a) is illuminated (red
LED), it indicates that the
charge status is at minimum.
With the battery discharged [red LED il-
luminated], the machine turns off or will
not start and the LED "R" of the battery
charger flashes for a few seconds; the
battery needs recharging.
2) Aspirator button
By setting the button (2) to "I", the aspira-
tor begins to operate.
Aspirator operation is enabled when the
button (3) is set to "I" or "II".
3) Brush rotation/water supply button
By setting the button (3) to "I", the circuits
are powered and brush rotation is ena-
bled.
The starting of rotation of the brush is
controlled by pressing levers (4).
By setting the button (3) to "II", the circuits
are powered and brush rotation and wa-
ter supply are enabled.
The start of brush rotation and water sup-
ply is controlled by the levers (4).
4) Brush rotation and/or water dispens-
ing lever
Pressing the levers (4) and holding them
pressed, starts the rotation of the brush
and, if enabled, the dispensing of water.
battery
4
EN-12
1c
1b
1a
1
2
R
4
3
Fig. 8