IMPORTANT: Make sure that mains cable is not caught under the appliance during and after
carrying / moving the appliance, to avoid the mains cable becoming cut or damaged."
When positioning your appliance take care not to damage your flooring, pipes, wall coverings
etc. Do not move the appliance by pulling by the lid or handle. Do not allow children to play
with the appliance or tamper with the controls. Our company declines to accept any liability
should the instructions not be followed.
Before Using Your Freezer
•
Remove the outer and inner packaging.
•
Before plugging in the freezer, leave it in a horizontal position for 4 hours. This will
reduce the possibility of malfunction in the temperature control system due to
mishandling during transport.
•
Clean the inside of the appliance as recommended in the "CLEANING AND
MAINTENANCE" section.
•
Insert the plug into the wall outlet and turn on the power supply, while the red light is
on. Avoid accidental disconnection by taping the switch. The green light comes on and
the compressor starts working.
•
You will hear a noise when the compressor starts. The liquid and gas sealed in the
refrigeration system may also produce noise whether the compressor is working or not,
which is completely normal.
•
If you are going to store food that has already been frozen, open the lid of the freezer
and check that the freezer has reached the correct temperature. You can then place
your already frozen food in it.
•
Do not charge the device immediately after switching it on. Wait for the correct storage
temperature to be reached. We recommend checking the temperature with an accurate
thermometer.
Freezer location
When selecting a position for your appliance, you should make sure that the floor is level and
firm, and that the room is well ventilated. An average ambient temperature must be observed.
This temperature is specific according to the climatic class of the device.
SN – T: This refrigeration appliance is intended for use in ambient temperatures between 10°C
and 43°C.
Avoid placing your device near a heat source, for example, stove, boiler or radiator. If the
appliance is placed in an outbuilding or on a terrace, avoid direct exposure to the sun. Make
sure that the appliance is not placed close to humidity (tumble dryer for example) to avoid the
formation of condensation on the walls. Never place the appliance in a wall or recessed in built-
in cabinets or furniture. When your appliance is on, the grill at the back may become hot and
the sides hot.
23