Publicidad
Idiomas disponibles
Idiomas disponibles
the spool until about 6''(16 cm) remains on either
side. (See Fig. J3)
J3
Lubricating the gearbox (See Fig. K1, K2)
1. Remove the screw on the gearbox.
2. If there is no bevel gear grease on the end of the
screw, squeeze 5 g of the gear grease (SHELL
Gadus S2 V220 1) into the gear housing.
3. Refit and tighten the screw firmly.
4. Install the battery and run the trimmer for 1
minute to ensure the gear is evenly lubricated.
K1
EN
K2
12
Cleaning the air filter (See Fig. L1, L2)
1. Clean the area around the air filter. Use a damp
cloth or a soft brush.
2. Unscrew and remove the air filter.
3. Wash the air filter with running water to remove
the dirt.
4. Allow the air filter to dry in the air. And then install
it in the housing by thghtening the screw.
L1
L2
Maintenance intervals
It is recommended to lubricate the gearbox and
clean the air filter every 50 hours of operation based
on actual usage.
CLEANING
1. Switch off the trimmer and remove the battery.
1. Do not use aggressive detergents or solvents.
Clean the machine after use with a damp cloth
dipped in mild detergent.
2. Keep battery connection free of dirt and debris,
and clean with a soft and dry brush or cloth.
3. Do not spray water onto the motor and electrical
components.
4. Do not use pressure washer to clean your
machine.
Publicidad
