Torque screwdrivers are classed as
inspection, measuring and test
equipment. The calibration frequency will
depend on such factors as the accuracy
of the measurements taken, their
frequency, the typical loads applied
during use, ambient conditions during
use and the storage conditions when not
in use.
The intervals for calibrating and adjusting
this screwdriver are equivalent to the
processes applied at your company for
test equipment inspection. If your
company has no defined test equipment
inspection processes, have the torque
screwdriver calibrated and adjusted at
the latest once every 12 months or after
5,000 operations.
Please ensure all other regulations
applicable at the location are applied.
Disposal
Dispose of the torque screwdriver
through a qualified disposal organisation.
Adhere to any applicable regulations. If in
doubt, contact the recycling company.
The torque screwdriver is made of steel
and aluminium. The locking ring is made
of polycarbonate and the shaft sleeve of
polylefin.
35