LEGRAND care NOVO Go Manual Del Usuario página 20

Appendix 2
NOVO Go can be connected with other alarm devices, for example SMILE, TOUCH,
DOOR and PIR II, refer to NOVO Go Technical Handbook, or follow the steps below:
ADD A TRANSMITTER
1. Go Into Configuration Mode by pressing the buttons in the sequence as follows:
Extra Button – Alarm Button – Extra Button – Alarm Button.
2. NOVO Go says: "Speaker Volume".
3. Press the extra button again, Novo Go says: "Add Transmitter".
4. Press the alarm button, Novo Go gives a short tone and the alarm button starts to
flash.
5. Press the alarm button on the alarm device that shall be paired.
A short confirmation sound is played and NOVO Go continues to the next
configuration setting in the Configuration mode menu "Range test mode".
6. Press the Extra Button to exit the Configuration Mode, or wait 5 seconds to exit
automatically.
A2.1 Send Alarm with Alarm Device
On the connected alarm device, press the alarm button. NOVO Go sends the alarm,
with position details, to the alarm central, refer to
A2.2 Answer Voice Call with Alarm Device
To answer an incoming voice call, press the alarm button on the connected alarm
device, refer to
NOVO Go User Manual NE41 21002-02 (EN)
Connect with Alarm Devices
6 Incoming Voice Call.
5 Send Alarm with NOVO Go.
18