BRITAX RÖMER KIDFIX SICT Manual página 3

KIDFIX SICT
KIDFIX SICT
The
installation:
1. "Semi-universal"
with the KIDFIX locking arms
into the ISOFIX fastening
points
This means: You can additionally fasten
the child safety seat into the ISOFIX
fastening points of the vehicle using the
KIDFIX locking arms. However, this
method of installation may only be used in
those vehicles cited in the following vehicle
type list.
• This type list is constantly updated. The
latest version can be obtained from us or
from our homepage: www.britax.eu /
www.roemer.eu
• Caution! Always secure your child with
the vehicle's 3-point seatbelt.
• Please note: In some vehicles the
headroom in the rear seat is limited. If
you fasten the
KIDFIX locking arms in these vehicles, it
may not be possible to use the child seat
up to a body height of 1.50 m. This may
be the case, for example, if the KIDFIX
headrest hits the vehicle's C-pillar.
Please observe the heights
shown in the type list.
2
is approved for two different methods of
KIDFIX SICT
with the
2. "Universal"
with the vehicle's 3-point
seatbelt
This means: The child car seat is
universally approved for installation using
the tested 3-point automatic seatbelt (in
accordance with ECE R 16 or comparable
standard) in all vehicles.
• This is a "universal" child restraint
system. It is approved in accordance
with ECE R 44/04 for general use in
vehicles and will fit most, although not
all, vehicle seats.
• The correct installation described by the
vehicle manufacturer in the owner's
manual presumably refers to the
vehicle's suitability for a "universal" child
restraint system for this age group.
• This child restraint system has been
categorised under stringent conditions
as "universal", as was the case with
earlier models that do not bear this label.
• If in doubt, please refer to the
manufacturer or the vendor of the child
restraint system.