Publicidad
Idiomas disponibles
Idiomas disponibles
SAFETY INSTRUCTIONS
CIRCULAR SAW WITH
INNER PENDULUM
GUARD
LOWER GUARD
FUNCTION
a)
Check lower guard for proper closing
before each use. Do not operate the saw
if lower guard does not move freely and
close instantly. Never clamp or tie the
lower guard into the open position. If saw is
accidentally dropped, lower guard may be bent.
Raise the lower guard with the retracting handle
and make sure it moves freely and does not touch
the blade or any other part, in all angles and depths
of cut.
b)
Check the operation of the lower guard
spring. If the guard and the spring are not
operating properly, they must be serviced
before use. Lower guard may operate sluggishly
due to damaged parts, gummy deposits, or a build-
up of debris.
c)
Lower guard may be retracted manually
only for special cuts such as "plunge cuts"
and "compound cuts." Raise lower guard by
retracting handle and as soon as blade enters the
material, the lower guard must be released. For
all other sawing, the lower guard should operate
20
automatically.
d)
Always observe that the lower guard is
EN
covering the blade before placing saw
down on bench or floor. An unprotected,
coasting blade will cause the saw to walk
backwards, cutting whatever is in its path. Be
aware of the time it takes for the blade to stop after
switch is released.
ADDITIONAL SAFETY
RULES FOR YOUR
CIRCULAR SAW
1.
Only use saw blades recommended in the
specification.
2.
Do not use any abrasive wheels.
3.
Use only blade diameter(s) in accordance with the
markings.
4.
Identify the correct saw blade to be used for the
material to be cut.
5.
Use only saw blades that are marked with a speed
equal or higher than the speed marked on the tool.
SYMBOL
To reduce the risk of injury, user must
read instruction manual
Warning
Wear ear protection
Wear eye protection
Wear dust mask
Double insulation
COMPONENT LIST
1.
SAFETY ON/OFF SWITCH
2.
FIXED GUARD
3.
BASE PLATE
4.
MOVABLE GUARD
5.
MOVABLE GUARD LEVER
6.
SAW BLADE
7.
BASE PLATE BEVEL LOCK
8.
LOCK OFF BUTTON
9.
SPINDLE LOCK BUTTON
10. DEPTH ADJUSTMENT KNOB
11. DEPTH OF CUT SCALE
12. SOCKET SPANNER
13. DUST EXTRACTION OUTLET
14. INNER FLANGE
15. SAW BLADE BOLT
16. OUTER FLANGE
17. SPINDLE
18. BASE PLATE ANGLE SCALE
Publicidad
