Publicidad
Idiomas disponibles
Idiomas disponibles
2. Introduction
Manufacturer:
Scheppach GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear Customer
We hope your new tool brings you much enjoyment and
success.
Note:
In accordance with the applicable product liability laws,
the manufacturer of this device assumes no liability for
damage to the device or caused by the device arising
from:
• Improper handling,
• Failure to comply with the operating instructions
• Repairs carried out by third parties, unauthorised
specialists.
• Installing and replacing non-original spare parts
• Application other than specified
• Failure of the electrical system in the event of the
electrical regulations and VDE provisions 0100,
DIN 13 / VDE0113 not being observed
Please consider:
Read through the complete text in the operating manu-
al before installing and commissioning the device.
The operating manual is intended to help the user to
become familiar with the machine and take advantage
of its application possibilities in accordance with the
recommendations.
The operating manual includes important instructions
for safe, proper and economic operation of the device,
for avoiding danger, for minimising repair costs and
downtimes, and for increasing the reliability and ex-
tending the service life of the device.
In addition to the safety instructions in this operating
manual, you must also observe the regulations appli-
cable to the operation of the device in your country.
Keep the operating manual package with the machine
at all times and store it in a plastic cover to protect it
from dirt and moisture. They must be read and careful-
ly observed by all operating personnel before starting
the work.
The device may only be used by personnel who have
been trained to use it and who have been instructed
with respect to the associated hazards. The required
minimum age must be observed.
In addition to the safety instructions in this operating
manual and the separate regulations of your country,
the generally recognised technical rules relating to the
operation of such machines must also be observed.
We accept no liability for accidents or damage that
occur due to a failure to observe this manual and the
safety instructions.
3. Device description (fig. 1 - 3,
16 - 17, 19, 20, 23, 27, 29, 31, 36, 39)
1.
Saw blade
1a.
Hexagon screw
1b.
Outer saw blade flange
1c.
Inner saw blade flange
2.
Saw blade guard
2a.
Fixing screw
3.
Riving knife
3a.
Fixing screw
4.
Table inlay
4a.
Fixing screw
5.
Saw table
6.
Extraction hose
7a.
Rear guide rail
7b.
Front guide rail
8.
Parallel stop
8a.
Guide rail / stop rail
8b.
Eccentric lever
8c.
Hexagon screw
9.
Table width extension right
10.
Push stick
11.
Right table width extension locking lever
12.
Scale
13.
Wheel
14.
Locking latch
15.
ON/OFF switch (green "I" ON switch, red "0"
OFF switch)
16.
Crank wheel
17.
Overload switch
18.
Locking lever
19.
Transverse stop
19a. Screw clamp
19b. Guide rail / stop rail
19c. Clamping handle
19d. Knurled nuts
19e. Wing nut for screw clamp
19f.
Wing nut for transverse stop
20.
Table width extension left
20a. Wing nuts
21.
Sliding carrier plate
21a. Wing nut
www.scheppach.com
GB | 35
Publicidad
