Publicidad
Idiomas disponibles
Idiomas disponibles
Always mow slopes at right angles to the incline; never mow
up and down.
When mowing slopes, be especially careful when changing di-
rection.
Never mow steep slopes.
Be especially careful when mowing backwards and pulling the
lawnmower towards you.
Switch the mower off when tilting it, running on empty or trans-
porting the lawnmower, e.g. to/from a lawn or along paths.
Never use the lawnmower if safety devices are faulty or mis-
sing, such as deflector and/or grass catchment devices.
Caution: do not touch running cutters.
Always keep hands and feet away from rotating parts. Do not
stand in front of the grass ejector opening.
Never lift or carry a lawnmower while the motor is running.
Never open the guard flap while the motor is still running.
Before removing the grass catchment device, turn off the mo-
tor and wait until the cutting gear has stopped running. After
emptying the grass catchment device, reattach carefully.
Never drive across gravel while the motor is running – impac-
ting stones!
Avoid mowing wet grass where possible.
Switch off the lawnmower, pull the mains plug and wait for the
lawnmower to stop running if, for example:
–
leaving the lawnmower
–
unblocking a blade
–
intending to check, clean or work on the lawnmower
–
you have encountered a foreign object, in which case you
should check the lawnmower for damage and carry out any
necessary repairs.
–
the lawnmower is vibrating heavily (switch off immediately
and ascertain the cause).
–
you wish to change the settings or carry out cleaning work.
Assembly
Fasten handle bars
A
1
Caution!
The cable can be damaged while folding up or pulling out
the handle bar.
When adjusting the handle height take care that the
cable is not crimped
See illustrations.
Operation
Operating times
Please check noise abatement regulations prevailing in your
country.
Adjust cutting height
1
Attention! Rotary cutter blade
Undertake work/adjustments on the equipment only after
the motor is switched off and the cutting tool has come to a
standstill.
1. Pull the lever out (1).
2. Set the desired cutting height (2).
3. Press the lever back in (3).
G
B
C D
E
G H
–
you wish to check whether the connection cables have be-
come tangled or damaged.
–
If the connection cable is damaged during use, it must be
immediately disconnected from the mains power supply.
Do not touch the cable before it has been disconnected
from the mains power supply.
Maintenance
1
Attention! Rotary cutter blade
Before all maintenance and cleaning work:
Pull out the power plug.
Do not touch running blades.
Never spray down the lawnmower using water, especially not
at high pressure.
Regularly check and tighten all visible screws and nuts, espe-
cially those relating to the cutting bar, to ensure a firm fit.
Always have blades changed or re-sharpened by a specialist
workshop, since a balance test must be carried out as speci-
fied in the safety regulations following any removal of parts.
Only use original WOLF-Garten spare parts. Otherwise we
can't guarantee that your mower conforms to the safety regu-
lations.
Never park your lawnmower in damp rooms.
For safety reasons, replace worn or damaged parts.
Disposal
Do not dispose of electrical equipment in domestic
waste. Recycle equipment, accessories and pa-
ckaging in an environment-friendly manner.
Mount the collecting bag
See illustrations.
3
Selection of Cutting height
If possible, mow when grass is dry in order to protect turf.
Do not se cutting position too low when mowing very hight
or wet grass.
Fit the collecting basket
1
Caution! Rotating cutters
Settings only to be carried out on the mower with the motor
switched off and with the cutting tools at a standstill.
Only insert the collection basket when your feet are at a
safe distance from the cutting tools.
F
J
11
Publicidad
