Council Directive 2002/96/EC concerning Waste Electrical
and Electronic Equipment (WEEE). Indicates a requirement
not to dispose of WEEE as municipal waste. Contact your
local distributor for information regarding disposal of the
unit and accessories.
Dangerous Voltage
2 Directions for Use (Patient)
NOTE: THE FOLLOWING STEPS ASSUME THAT YOUR CLINICIAN HAS SET
UP THE DEVICE FOR YOU. IF YOU ARE UNSURE, CALL YOUR CLINICIAN
BEFORE PROCEEDING. THE INSTRUCTIONS BELOW DESCRIBE ALL OF THE
BUTTONS YOU SHOULD BE PRESSING TO WORK THE DEVICE. PLEASE
NOTE THE "SETUP" BUTTON IS INTENDED FOR CLINICIAN USE.
Getting Started
2.1
Your kit may include:
• AA Batteries
• Belt Clip
• Carrying Case
• Electrodes and Touchproof Lead Wires
Note: Your electrodes have been specified by your clinician as part of
the prescription.
• 300 PV Device
• Battery charger and instructions for use
• Instruction Manual
2.2 Using the Front Panel
Before you use the device you should be familiar with the location of the intensity
controls, ON/OFF button and the indicator lights.
Note: A full description of all controls and indications is located in the 300 PV
Hardware and Labeling section of this manual.
Step 1. Open the flip cover of the device as shown in Figure 1.
Step 2. The front panel should appear as shown in Figure 1. Press the red ON/
OFF switch on the front panel. You should see characters
displayed on the LCD. The device is now ready to function. Note: If the
device does not respond, skip to step 6.
11