ivoclar Stratos 300 Instrucciones De Uso página 12

5. Handling and Operation
5.2.2 PR stop (9.2) for centric shift
The PR stop permits each condyle to be
incrementally advanced from 0 to 4 mm into a
protrusive position.
9.2
9. 1
Loosen the screw for the PR stop (9.1) and move the
PR stop (9.2) into the desired position on the PR scale
(9.0). By fastening the screw for the PR stop (9.1), the
position can be fixed.
Important:
In this case, the centric fixation cannot be
used.
12
5.3
The lateral movements can be simulated when the
centric fixation (4.1) is open, according to the
schematic below. To perform this movement, press
with your thumb unilaterally on the joint of the
corresponding side.
9.0
Bennett angle
By loosening the B knurled screw (3.2), the Bennett
angle can be read off, adjusted and fixed with the
Bennett angle scale (3.3).
3.2
Lateral and Bennett movement