Hilti PM 20-CG Manual De Instrucciones Original página 31

▶ If the battery is too hot to touch, it may be defective. Put the battery in a place where it is clearly visible
and where there is no risk of fire, at an adequate distance from flammable materials. Allow the battery to
cool down. If it is still too hot to touch after an hour, the battery is faulty. Consult Hilti Service or read the
document entitled "Instructions on safety and use for Hilti Li-ion batteries".
Observe the special guidelines applicable to the transport, storage and use of lithium-ion batteries.
→ page 40
Read the instructions on safety and use of Hilti Li-ion batteries that you can access by scanning
the QR code at the end of these operating instructions.
2.7 Careful handling and use of batteries.
PM 20­CG
PM 20­CGE
▶ Remove the batteries from the product if it is to remain unused for a lengthy period of time. Batteries can
corrode and self-discharge during prolonged storage.
▶ Make sure that batteries are inaccessible to children.
▶ Do not mix old and new batteries. Always replace all batteries at the same time. Do not mix batteries of
different makes or types.
▶ Do not use damaged batteries.
▶ Use only the battery type intended for this product. Use of other batteries may create a risk of injury and
fire.
▶ When replacing batteries, make sure that polarity is correct and that correct procedure is followed. There
is a risk of explosion.
▶ Do not allow batteries to overheat and do not expose them to fire. Batteries can explode and release
toxic substances.
▶ Do not attempt to charge non-rechargeable batteries.
▶ Do not solder batteries into the product.
▶ Do not discharge batteries by short-circuiting. Batteries can develop a leak, explode, catch fire and injure
persons.
▶ Do not damage batteries and do not attempt to take batteries apart. Batteries can develop a leak,
explode, catch fire and injure persons.
*2328447*
2328447 English 27