Technical Data; Operation; Initial Operation - Bosch Active Line Gen.3 Manual Del Propietário

English–5

Technical Data

On-board computer
Article number
1)
Batteries
Operating temperature
Storage temperature
2)
Protection type
Weight, approx.
1) We recommend using the batteries offered by Bosch. You can pur-
chase them from your eBike dealer (part number: 1 270 016 819).
2) When USB cover is closed
This device is in compliance with Part 15 of the FCC Rules. Operation
is subject to the following two conditions:
(1) This device must not cause harmful interference, and
(2) this device must accept any interference that is received,
including interference that may cause undesired operation.
This device is in compliance with CAN ICES-3(B)/NM B-3(B).
Bosch eBike system uses FreeRTOS (see www.freertos.org)

Operation

Requirements
The eBike system can only be activated when the following
requirements are met:
– A sufficiently charged battery pack is inserted (see
battery pack operating instructions).
– The speed sensor is connected properly (see drive unit
operating instructions).

Initial Operation

Switching the eBike System On/Off
Options for switching on the eBike system:
– Press the On/Off button 1 of the on-board computer
with the eBike battery pack inserted.
– Press the On/Off button of the eBike battery pack (see
battery pack operating instructions).
Once it is switched on, the eBike system is in the "OFF"
mode. Select the desired assistance level and take off.
The drive is activated as soon as you put pressure on the
pedals. The assistance level depends upon the on-board
computer settings.
1 270 U20 XBP | (23.5.17)
Purion
1 270 020 916/917
2 x 3 V CR2016
°F +23...+104
°F +14...+122
IP 54 (dust and splash
water protected)
lb 0.2
As soon as you stop pedaling when in normal operation, or
as soon as you have reached a speed of 20/28 mph, the
assistance from the eBike drive unit is switched off. The
motor assistance is automatically re-activated as soon you
start pedaling again and the speed is below 20/28 mph.
Options for switching off the eBike system:
– Press the On/Off button 1 of the on-board computer.
– Switch off the eBike battery using its On/Off button
(bicycle manufacturer-specific solutions are possible
whereby there is no access to the battery On/Off button;
see the bicycle manufacturer operating instructions).
The system shuts down after being switched off; this takes
approximately 3 seconds. It cannot be switched back on
immediately until shutdown has been completed.
If the eBike is not moved and no button is pressed on the
on-board computer for 10 minutes, the eBike system will
shut down automatically in order to save energy.
Note: Always switch off the eBike system when you park
the eBike.
Note: If the batteries of the on-board computer are empty,
you can still switch on your eBike using the bike's battery
pack. It is, however, recommended that you replace the
internal batteries as soon as possible in order to avoid
damage.
Indications and Settings of the on-board
computer
Symbols and their meaning
Symbol Explanation
short button press (less than 1 second)
medium button press (between 1 second and
2.5 seconds)
long button press (longer than 2.5 seconds)
Energy supply of the on-board computer
The on-board computer is supplied with voltage by two
CR2016 button cells.
78
Bosch eBike Systems