Publicidad
STEP 1 – PASO 1 – ÉTAPE 1 – FASE 1 – STEP 1 – STAP 1
Lock the Front Stabilizer (pt.2) to the Main Frame (pt.1) with four sets of Ø8 Flat Washer (pt.5) and M8 Bolt
(pt.3). Lock the Rear Stabilizer (pt.4) to the Main Frame (pt.1) with four sets of Ø8 Flat Washer (pt.5) and M8 Bolt
(pt.3).
STEP 2 – PASO 2 – ÉTAPE 2 – FASE 2 – STEP 2 – STAP 2
Put the Vertical Seat Post (pt.9) slip into the seat post tube on the Main Frame. You will have to slacken the
knurled section of the Knob (pt.7) and pull the knob back and then select the desired height. Release the knob
and retighten the knurled portion. Then put the Seat Post (pt.8) on the Vertical Seat Post (pt.9), use the Knob
(pt.11) and the Flat Washer (pt.12) to lock.
Finally,the Seat (pt.13) fixed on the Seat Post (pt.8) as shown, and lock the nuts under the seat
FYTTER |WWW.FYTTER.COM
PAG- 13
Publicidad
