Publicidad
STEP 3 – PASO 3 – ÉTAPE 3 – FASE 3 – STEP 3 – STAP 3
Put the Handlebar Post (pt.51) slip into the handlebar post tube on the main frame. You will have to slacken the
knurled section of the Knob (pt.7) and pull the knob back and then select the desired height. Release the knob
and retighten the knurled portion. Then the Handlebar (pt.6) fixed on the Handlebar Post (pt.51) with the Knob
(pt.11) and the Flat Washer (pt.12). The Bluetooth Holder (pt.71) fixed on the handlebar as shown. The Plug (A1)
of the Sensing Line inserted into the sensor input hole on the Bluetooth Holder.
STEP 4 – PASO 4 – ÉTAPE 4 – FASE 4 – STEP 4 – STAP 4
The Pedals (pt.15L & pt.15R) are marked "L" and "R" - Left and Right. Connect them to their appropriate crank
arms. The right crank arm is on the right- hand side of the cycle as you sit on it. Note that the Right pedal should
be threaded on clockwise and the Left pedal anticlockwise.
Gap
A2
Convex point
ATTENTION:：Connected with the computer
line, to Gap(A1) corresponding to the convex
point (A2) to insert link
FYTTER |WWW.FYTTER.COM
A1
FIG.3-1
PAG- 14
Publicidad
