Automatic Operation; Program Selection - Orbis Thermo X Manual De Uso

When in automatic mode it is possible to assign one of the three available
temperatures to each of the 24 hour segments: T0, T1 or T2.
This enables the user to fi nd his/her home comfortably heated in the hour segments
of his/her preference; when the user is not in or at night, the device will see to
keeping a lower room temperature.
Seven preset daily temperature profi les (Programs) are available for both
WINTER-HEATING and SUMMER-AIR CONDITIONING operating modes.
Each of these profi les can be customized following specifi c user requirements.
The display will show the temperature associated to the 24 hours as follows:
- 2 "small squares" on top of each other: to adjust the temperature starting from
the set value by pressing key
- 1 "small square": to adjust the temperature from the set-point,
by pressing key
- no "small square": to adjust the temperature from the set-point,
by pressing key
Factory settings (Default) feature the temperature profi le corresponding to Program
1 for Monday through Friday; Program 2 for Saturday and Sunday (refer to the
profi les on page 76).

PROGRAM SELECTION

This procedure changes operating hours and temperature profi les, choosing among
the seven available preset programs, and assigning these to each of the days in the
week.
1. Press : the following reading will appear
2. Press or to select the hourly schedule to be assigned to Monday (cfr. page 76
for Winter-Heating, or page 77 for Summer-Air conditioning)
3. Press to confi rm; the day of the week will change
4. Repeat steps 2 and 3 to select the hourly schedule to be assigned to the
remaining days of the week
5. After the Sunday schedule is confi rmed the device exits programming and resumes
normal operation

AUTOMATIC OPERATION

(temperature T2)
(temperature T1)
(temperature T0)
- 73 -
User Manual - Thermo X