Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly - Hanging the Fan (continued)
3
Preparing the remote control
NOTE: The remote control has already been paired to the
ceiling fan for your convenience. If you have two of the same
model fans in your home, please follow the steps below to
control each fan independently.
NOTE: The remote control battery will weaken with age and
should be replaced before leaking takes place, as this will
damage the remote control. Dispose of used battery properly
and keep the battery out of the reach of children.
NOTE: The switch marked "O/D" controls the dimming
function of the lights. If using non-dimmable bulbs, use a
ballpoint pen or small screwdriver to set the switch to "O" to
disable the dimming function. If using dimmable bulbs, set
the switch to "D" to enable the dimming function.
□
Confirm that the power to the fan is off at either the wall switch or
breaker box.
□
Remove the battery cover by pressing firmly on the arrow and
sliding the cover off.
□
Install two 1.5V AAA batteries (N).
□
Return power to the fan at the wall switch or breaker box.
□
If the remote control doesn't work as normal, press then release
the "Learn" button for 1-2 seconds (located in the remote's battery
compartment) within 30 seconds of turning on the power.
□
If pairing is successful, the fan's light kit will flash and the blades
will begin to spin.
□
Replace the battery cover on the remote control.
1 to 3 mode
□
To use more than one remote control for your fan, press the "Learn"
button for 10 seconds and release within 30 seconds of turning on the
power. Once pairing is successful, the fan's light kit will flash and the
blades will begin to spin.
□
Repeat the above process for the remote controls you want to work
with this fan.
□
The fan can be only controlled by 3 remote controls maximum at the
same time after "Learning". If you use a fourth remote control to handle
the fan, the first remote control will be replaced.
1 to 1 mode
□
To use only one remote control for your fan, press and release the
"Learn" button for 1-2 seconds within 30 seconds of turning on the
power. The "1 to 3" mode will be cleared and returned back to "1 to
1" mode.
LEARN
K7
4
Installing the receiver
WARNING: To reduce the risk of fire or electric shock,
remember to disconnect power. The electrical wiring
must meet all local and national electrical code
requirements. The electrical source and fan must
be 110/120 volts, 60Hz. Do not use this product in
conjunction with any variable wall control. Incorrect
wire connection can damage this receiver.
CAUTION: If other fan wires are a different color, have
this unit installed by a licensed electrician.
CAUTION: Do not install in a damp location or immerse
in water (for indoor use only). Do not pull on or cut leads
shorter. Do not drop or bump the unit.
□
Position the house supply wires (AAA) to one side of the
slide-on mounting bracket (A). Position the fan wires to the
opposite side.
□
Insert the narrow end of the receiver (K) (as shown, flat side
towards the ceiling) into the slide-on mounting bracket (A)
until it rests on top of the ball/downrod assembly (B).
A
AAA
A
N
9
Please contact 1-877-592-5233 for further assistance.
BBB
B
C
View after installation
HOMEDEPOT.COM/HUBSPACE
K
Publicidad
