Publicidad
Idiomas disponibles
Idiomas disponibles
Unpacking and Setup
Section 1
1. Remove light from package.
2. Unscrew tailcap.
3. Remove battery insulator (round disc) located at rear of battery.
Insulator should fall out of barrel when light is tilted head up.
4. Install pocket clip onto barrel from the tailcap end (push round part
of clip all the way forward until it stops on knurl). Insert cam lock tool
into cam lock and rotate clockwise approximately ¼ to ½ turn, to lock
pocket clip on barrel.
5. Screw tailcap back onto barrel.
6. Remove charging base, USB cable and wall adapter from package.
7. Connect cable to charging base, wall adapter or cigarette adapter. Then
plug into appropriate power source.
8. Install assembled light into charging base and charge until fully charged
(solid green LED indication on base).
4
3
Charging Base
There are provisions for mounting the base if desired. Any #10 or M3.9
screw with a low profile truss head, will go through the center of the
charging base. Screw head must be no larger than an .484 in. or 12.3 mm.
And, head height must be no longer than .130 in. or 3.3 mm. Use
appropriate threads for the type of material to which
the base is mounted.
Mount vertically only on horizontal surface with open
end up.
7
5
Publicidad
