Descargar Imprimir esta página

Frigelux D370ST Serie Instrucciones De Uso página 20

Publicidad

Idiomas disponibles

Idiomas disponibles

INSTALLATION INSTRUCTIONS
➢ Before using your unit
Remove the exterior and interior packing.
Carefully remove the appliance from the pallet, and make sure not to damage the appliance
during the unloading.
Please find the feet of the cooler provided inside. Insert them in the screwed sockets at the
bottom of the cooler and make the height adjustment.
Before connecting the unit to the power source, let it stand upright for approximately 2 hours.
This will reduce the possibility of a malfunction in the cooling system from handling during
transportation.
Clean the interior surface with lukewarm water using a soft cloth.
➢ Installation of your unit
This refrigerating appliance is not intended to be used as a built-in appliance.
Place your appliance on surface able to support the device once it is fully charged. To level your
device, adjust the adjustable feet under the cooler.
Allow 15cm of space between the back and sides of the unit, which allows the proper air
circulation to cool the compressor and condenser.
An average ambient temperature must be observed. This temperature is specific according to
the climatic class of the device:
Climatic class
CC1
CC2
CC3
Your appliance is of climate class CC2 (maximum temperature and humidity are equal to +32°C
and 65% ambient humidity). This climatic class is indicated on the rating label located inside
your showcase (class 4).
▪ To open completely the doors without locking the shelves, there should be enough space on the
side of the appliance (about 1.5 cm at the hinges and 1m wide with the door open)
Locate the unit away from direct sunlight and sources of heat (stove, heater, radiator, etc.).
Direct sunlight may affect the acrylic coating and heat sources may increase electrical
consumption. Extreme cold ambient temperatures may also cause the unit not to perform
properly.
Avoid locating the unit in moist areas. Too much moisture in the air will cause frost to form
quickly on the interior surface requiring more frequent defrosting of the unit.
Maximum ambient
temperature
25°C
32°C
40°C
18
Maximum ambient
humidity
60%
65%
75%

Publicidad

loading

Este manual también es adecuado para:

D370top serie