Publicidad
Idiomas disponibles
Idiomas disponibles
Storage of beverages
This showcase is intended exclusively for the storage of non-perishable packaged beverages.
We remind you that the storage of foodstuffs must comply with regulatory storage temperatures
established by the National Agency for Food, Environmental and Occupational Health and Safety
(ANSES). Failure to respect these storage temperatures involves risks of poisoning and food waste.
➢ Change the lamp
This appliance consists of light-emitting diodes (LEDs). This type of diode
cannot be changed by the consumer. The lifetime of these LEDs is normally
sufficient for no change to be made. If however, and despite all the care
taken during the manufacture of your appliance, the LEDs were defective,
please contact your after-sales service for any intervention.
CARE AND MAINTENANCE
➢
Cleaning and defrosting your unit
Your cooler is devised with an automatic defrosting system. Defrost water accumulates in the channel
underneath the evaporator. It is then carried to the drip tray by the help of a hose where it evaporates.
However, after the cooler working for some time, frost will form on the surface of the evaporator. The
thicker the frost is, the hotter resistance is. The hot resistance will reduce the effect of the refrigerant.
Please defrost, when the frost is thicker than 5mm.
•
Please set the control knob to "0" and disconnect the power supply before defrosting the cooler.
•
The solution should be about 2 tablespoons of baking soda to a quart of water.
•
Open the door, and take out the beverages. Knock the frost gently. Wait until the defrost water
is drained. Please clean with soft cloth dipping with warm water or neutral soap liquid. Be sure
to wipe with pure water after using neutral soap liquid.
•
Never attempt to scrape/remove ice /frost with sharp objects (such as knives, shovels, etc.). Or
the evaporator will be broken down.
•
After defrosting, connect the cooler to the power supply and wait 2 hours before filling it again
CAUTION
Failure to unplug the unit could result in electrical shock or personal injury.
•
In order to optimize the energy consumption of your appliance, it is recommended to dust the condenser
located at the backside of your device.
➢
Power failure
Most power failures are corrected within a few hours and should not affect the temperature of your
unit if you minimize the number of times the door is opened. If the power is going to be 0 for a longer
period of time, you need to take the proper steps to protect your beverages.
➢
Moving your unit
▪
Unplug your appliance.
▪
Remove all the beverage.
▪
Tape the door shut.
▪
Be sure the unit stays in the upright position during transportation.
20
Publicidad
