Husqvarna 525iB Mark II Manual De Usuario página 10

2. Put the battery in the battery charger.
3. Make sure that the green charging light on the
battery charger comes on. That means that the
battery is connected correctly to the battery charger.
4. When all LEDs on the battery come on, the battery is
fully charged.
5. To disconnect the battery charger from the mains
socket, pull the plug. Do not pull the cable.
6. Remove the battery from the battery charger.
Note:
Refer to the battery and battery charger
manuals for more information.
To connect the battery to the product
WARNING:
original batteries in the product.
1. Make sure that the battery is fully charged.
10
Only use Husqvarna
2. Slide the battery into the battery holder of the
product. The battery must slide easily, if not, it is not
installed correctly.
3. Press the lower part of the battery and push it in as
far as it will go into the battery compartment. The
battery will lock into position when you hear a click.
4. Make sure that the latches snap in place correctly.
To start the product
1. Press and hold the start button until the green LED
light comes on.
2. Use the power trigger to control the speed.
To stop the product
1. Release the power trigger.
2. Push and hold the power button until the green LED
light comes off.
3. Remove the battery from the product. Push the two
release buttons and pull out the battery.
1601 - 003 - 13.01.2023