Husqvarna 525iB Mark II Manual De Usuario página 11

To set the optimal airflow for your work
1. Press the power trigger to choose the optimal airflow
for your work.
2. Press the cruise control button to set the chosen
airflow, the LED comes on.
3. Continue to work without needing to press the power
trigger.
Introduction
WARNING:
maintenance work you must read and
understand the safety chapter.
Maintenance
Clean the outside of the machine with a clean and dry cloth. Never use water.
Keep handles dry, clean and free from oil and grease.
Make sure that the start/stop button works correctly and is not damaged.
Make sure the power trigger is functioning properly with regard to safety.
Check that nuts and screws are tight.
Check that the battery is intact.
1601 - 003 - 13.01.2023
Maintenance
Before you do any
4. Press the cruise control button again to deactivate
the cruise control function.
To temporarily increase the airflow
1. Start the product. See
10 .
2. Press and hold the boost button to get the maximum
airflow, the LED comes on.
a) 525iB Mark II has unlimited boost time.
b) has a limited boost time of 30 seconds. Release
and press the boost button again.
3. Release the boost button to use the product with
normal air flow.
Maintenance schedule
WARNING:
you do maintenance.
The following is a list of the maintenance steps that you
must do on the product.
To start the product on page
Remove the battery before
Daily Weekly Monthly
X
X
X
X
X
X
11