Volkswagen 5NA 092 101 Instrucciones De Montaje página 35

Route the red/white, red/blue, red/violet and red/yellow ends of the 9-wire wiring harness up to the
interior load distributor and then insert them into the respective unoccupied output side fuse slots
(marked with an "A", e.g.,"F22A") as shown in Table 2 and click into place.
Wire Fuse slot no.
red/white
red/blue
red/violet
red/yellow
Connect up the red 1-wire wiring harness as follows:
Slide the supplied protection cap, 1-way white in the correct direction onto the 1-wire red wiring
harness and then insert the 4.8 mm box contact into slot 121 at the rear of the interior load
distributor and click into place. Then slide the protective cap, 1-way white with the fixing tabs to the
front over the pre-fitted box contact and then attach in slot 121 at the rear of the interior load
distributor and click into place.
Insert the 4.8 mm blade receptacle into the input side of the F22 fuse slot and click into place.
Then insert the four supplied flat pin fuses into the respective fuse slots as shown in Table 2.
Route the orange/brown, orange/green, violet/black and black/red wire ends of the 9-wire wiring
harness BCM (Body Control Module).
Unlock the slot "C" connector housing on the BCM and then pull the connector strips out of the
housing casing. First remove the cable ties at the cable outlet of the connector housing.
Push out the socket contact of the vehicle's black/red wire from chamber 58 and insert it into
chamber 2 of the supplied 3-way black socket housing and click into place.
Insert the socket contact of the black/red wire end of the 9-wire wiring harness into the now free
chamber 58 and click into place. Reinsert the connector strips into the housing casing, lock and then
use a 143 mm cable tie to secure them in place.
Unlock the slot "A" connector housing on the BCM and then pull the connector strips out of the
housing casing. First remove the cable ties at the cable outlet of the connector housing.
Push out the socket contact of the vehicle's orange/green wire from chamber 16 and insert it into
chamber 3 of the supplied 4-way brown socket housing and click into place.
Push out the socket contact of the vehicle's orange/brown wire from chamber 17 and insert it into
chamber 4 of the 4-way brown socket housing and click into place.
Push out the socket contact of the vehicle's black/violet wire from chamber 14 and insert it into
chamber 1 of the 4-way brown socket housing and click into place.
Insert the socket contacts of the orange/green, orange/brown and black/violet wire ends of the 9-
wire wiring harness into the now free chamber 16 (orange/green), chamber 17 (orange/brown)
and chamber 14 (black/violet) and click into place. Reinsert the connector strips into the housing
casing, lock and then use a 143 mm cable tie to secure them in place.
Plug the 3-way black and 4-way brown pin housing of the wiring harness into the previously fitted 3-
way black and 4-way brown socket housings, click into place and then use a 143 mm cable tie to
secure them to the vehicle's wiring harness.
02.10.2015-054224
Fuse rating
F28 20A
F38 20A
F44 15A
F22 15A
Table 2:
Power supply trailer lighting right
Power supply trailer lighting left
Permanent positive trailer power supply (Ter.
Power supply charging cable trailer (Ter. 15)
Function
30)
11 / 91