Fluval FX UVC Manual De Instrucciones página 4

off, disconnect the power supply cord from mains (main
power supply).
C. Carefully examine the appliance after installation. It should
not be plugged if there is water on parts not intended to
be wet. If electrical components of the appliance get wet,
unplug the appliance immediately.
3. CAUTION – NEVER LOOK INTO A UV LAMP WHEN
SWITCHED ON. Direct exposure to ultraviolet light can
damage eyes and skin.
4. WARNING – This appliance can be used by children aged 3
years and above, persons with reduced physical, sensory or
mental capabilities or lack of experience and knowledge if
they have been given supervision or instruction concerning
use of the appliance in a safe way and understand the
hazards involved. Children shall not play with the appliance.
Cleaning and user maintenance shall not be made by
children without supervision. This product is not a toy. To
avoid injury, do not touch moving parts or hot parts.
5. CAUTION – Always unplug or disconnect all appliances
in the aquarium from the electrical supply before placing
hands in water, before putting on or taking off parts and
while the equipment is being installed, maintained or
handled. Never yank the cord to pull the plug from outlet.
Grasp the plug and pull to disconnect. Always unplug an
appliance from an outlet when not in use.
6. This appliance cannot be repaired.
7. This appliance comes with a 6 watt bulb that can be replaced.
8. This appliance requires no cleaning and is maintenance free.
Do NOT attempt to clean unit using water or other substance.
9. This appliance should only be used with the power supply
unit provided.
10. The supply cord cannot be replaced. If the cord is damaged
the appliance should be disposed of in the proper manner.
11. Do not operate any appliance if it has a damaged cord or
plug, or if it is malfunctioning or it is dropped or damaged
in any manner.
12. To avoid the possibility of the appliance plug getting
wet, position the tank to the side of a wall mounted
receptacle to prevent water from dripping onto the
receptacle. A "drip loop", should be arranged by the
user for each cord connecting an aquarium device
to the receptacle. The "drip loop" is the part of the cord
4