cecotec bolero COOLMARKET TT 107 WHITE Manual De Instrucciones página 59

4. Food storage
After the refrigerator has been in operation for some time, the user may adjust its internal
temperature. Once the refrigerator has reached a suitable interior temperature, put in the food.
If the refrigerator is installed in a wet place, be sure to check if the earth wire and the circuit
breaker are working normally. If vibration noises occur due to contact of the refrigerator
with the wall or if the wall turns black due to air convection around the compressor, keep
the refrigerator further away from the wall. The installation of the refrigerator may cause
noise interference or image problems in mobile phones, landline phones, radio receivers, or
televisions near the refrigerator, so in this case, keep the refrigerator as far away from these
objects as possible.
Changing the door opening direction
1. Make sure the refrigerator is unplugged.
2. Pry off the hole covers and screws, then pry off the top cover and remove the three screws
securing the top hinge to the door, then remove the hinge. Fig. 3
3. Remove the refrigerator compartment door.
4. Remove the screws that fix the lower hinge in the right side of the fridge and remove the
hinge. Fig. 4
5. Remove the washer and the nut that fix the shaft pin to the right gap of the lower hinge
and remove the shaft. Fig. 5
6. Introduce the shaft pin in the lower hinge left hole and fix the shaft with the washer and
the nnut. Fig. 6
7. Install the lower hinge on the left side of the fridge.
8. Disassemble the freezer compartment door
Unscrew the screw securing the lower door shaft bushing and store the removed
8.1.
door, screw and lower and upper shaft bushings. Fig. 7
Unscrew the screw holding the manual door lock to remove the manual lock. Fig. 8
8.2.
Install the manual door lock that has been removed on the right side. Fig. 9
8.3.
Install the lower and upper sleeves of the door shaft and the small door on the left
8.4.
side. Fig. 10
9. Remove the screw that holds the door stop on the lower right side of the refrigerator door
and remove the door stop from the door. Then install it in the lower left side. Fig. 11
10. Install the door refrigerator.
11. Move the door sleeve from the right top chamber of the refrigerator to the upper left side
of the door. And move the left hole lid to the right side. Fig. 12
12. Attach the top hinge to the left top chamber side of the cabinet with the three screws
removed earlier. Before tightening the top hinge screws, make sure that the top chamber
of the door is flush with the cabinet and that the rubber gasket makes a good seal.
13. Install the top cover on the fridge Fig. 13
BOLERO COOLMARKET TT 107 WHITE / INOX / BLACK
ENGLISH
59