Procusini mini Manual página 18

5. Print 3D Choco Refills/own chocolate
5.1 Preparation
5.2 Insert 3D Choco Refills (not applicable for chocolate)
Select the function "Insert" on the start screen to insert 3D Choco Refills. Follow
the instructions on the display and observe the following notes.
NOTE
Insert the refill including the foil with the open side down.
•
The refill must not protrude beyond the marking on the
•
outside of the cartridge.
Gently close the cartridge holder until it stops.
•
Place the device on a horizontal surface.
Insert the SD card with the gold contacts
facing the display.
Insert the printing table. Pay attention to the
arrows on the left and right. The arrows must
point to the back.
Place the silicone mat on the printing table.
Connect the power supply unit to a socket.
Connect the other end of the power supply unit
to the device via the power connector
(chapter 2, no. 7).
Take a refill and cut the foil slightly around the
refill at the marking. The Refill Cutter is
particularly suitable for this.
Now simply break the refill in half and insert
one half into the stainless steel cartridge.
18