Procusini mini Manual página 25

11. Troubleshooting
You can find more tips, tricks and video tutorials on the various applications
online in the Procusini Club. Especially tips on making your own chocolate.
3D Choco My refill is not empty yet, but I do not want to continue printing
Refills
Leave the machine as it is and switch it off at the power switch so that the
Choco can solidify. If you do not print for a longer period of time, you can
remove the stainless steel cartridge with the cold Choco using the
"Remove" function and store it at room temperature.
No Choco No choco/chocolate comes out of the nozzle
resp. no
If you have already restarted and pre­dosed again, check whether the nozzle of
chocolate
the stainless steel cartridge is clogged. Use a needle, for example, to do this.
Storage
Always store Procusini mini 3D Choco Refills at 15­20 °C. Storage in the refrigerator
leads to a longer preheating time.
Object My printed object has holes
First note:
• Make sure the room temperature is suitable (20 ­ 22 °C).
• Protect the Procusini mini from draughts during printing.
• Make sure that the refills are stored correctly at 15­20 °C.
• Check the nozzle for blockages, e.g. with a needle.
When you have checked the above points, note the following:
The first print layer is the most important. The Choco resp. chocolate strand must
be pressed firmly against the silicone mat by the nozzle and should not have any
interruptions.
Therefore, pre­dose sufficiently until the strand flows out of the nozzle without
interruption.
Can you tell that the strand is coming out of the nozzle correctly,
but the strand does not seem to be pressed sufficiently flat, reduce the distance
between the nozzle and the silicone mat by using the "Calibration" function in
the display.
Temp Error
The device shows "Temperature Error!"
• The refill is too long, shorten it (chapter 5.2) and try again.
• Make sure that the gold contacts in the cartridge holder and on the print head
are always free of dirt. This can cause faulty contact and the device will display
a temperature error.
• After cleaning, restart the device.
Silikone Mat The silicone mat slips
Make sure that the silicone mat and the printing table are always clean and free
of dust.
Dampen the underside of the silicone mat with a damp cloth, to prevent it from
slipping
EN
25