Descargar Imprimir esta página

MaxxHome 20501 Manual De Usuario página 29

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 35
Malfunction detection
light
* Based on Gross Calorific Value [Hrs]
4. Assembling Instructions
4. ASSEMBLING INSTRUCTIONS
Extract the heater from its carton. If the unit is anyhow damaged, do not use it and contact your deale
Extract the heater from its carton. If the unit is anyhow damaged, do not use it and contact your
dealer.
BGO1601-20: the heater is only need to fix the plastic handle, no further operations required (see F
20501: the heater is only need to fix the plastic handle, no further operations required
1).
(see Fig. 1).
20553 - 20503: The following accessories are supplied in the shipping carton.
BGO1601-30/BGO1601-50The following accessories are supplied in the shipping carton.
To assemble the heater, proceed as follows (see Fig. 2):
1、Insert the wheel shaft J to the corresponding hole of feet pipe E,insert the cotter K to the
corresponding holes; put plain washer H to the two sides of shaft, slide the wheel I over the whe
shaft J,screw the nut G to fix the wheel on the shaft.
2、Put the heater body on the feet pipe assembly, make sure the 4 holes of handle A point toward
To assemble the heater, proceed as follows (see Fig. 2):
corresponding 4 holes on the feet pipe respectively.
1. Insert the wheel shaft J to the corresponding hole of feet pipe E, insert the cotter K to the
corresponding holes; put plain washer H to the two sides of shaft, slide the wheel I over the
3、Using the screw B ,spring washer C, plain washer D and nut F to fix the feet pipe assembly and
wheel shaft J, screw the nut G to fix the wheel on the shaft.
handle to the tank.
2. Put the heater body on the feet pipe assembly, make sure the 4 holes of handle A point towards
the corresponding 4 holes on the feet pipe respectively.
3. Using the screw B, spring washer C, plain washer D and nut F to fix the feet pipe assembly and
handle to the tank.
5. Installation Instructions
Position the heater on a flat, level, non-flammable, solid surface.
Direct-fired heaters are intended for use in outdoor open areas or in indoor
ventilated areas. For indoor use, provide permanent ventilation openings of at leas
built-in
Fig. 1
Fig.1
Fig. 2
Fig.2
built-in
built-in
Pos.
Description
Pos.
Description
A
Screw
A
Screw
B
Plain washer
B
Plain washer
C
Handle
C
Handle
Pos.
A
Pos.
Description
B
A
Handle
C
D
B
Screw
E
C
Spring washer
F
D
Plain washer
G
E
Feet pipe
H
F
Nut M5
I
G
Nut M12
J
H
Plain washer ø12
K
I
Wheel
J
Wheel shaft
K
Cotter
Qty
Qty
2
2
2
2
1
1
Description
Qty
Handle
1
Qty
Screw
6or8
Spring washer
1
6or8
Plain washer
6or8
6or8
Feet pipe
1
6or8
Nut M5
6or8
6or8
Nut M12
2
1
Plain washer ø12
2
6or8
Wheel
2
2
Wheel shaft
1
2
Cotter
2
2
1
2
29

Publicidad

loading

Este manual también es adecuado para:

2055320503