DJI DB1560 Guía De Usuario página 6

• Always use a clean, dry cloth when cleaning the battery terminals.
• DO NOT fly when the battery power level is below 15% to avoid damage to the battery
and flight risks.
• Make sure the battery is correctly connected. Otherwise, the battery may overheat or
even explode due to abnormal charging. Only use approved batteries from authorized
dealers. DJI assumes no responsibility for any damaged caused by using batteries that
are unapproved.
• Make sure to lift the battery by the handle.
• Make sure the battery is placed on a flat surface to avoid damage to the battery from
sharp objects.
• DO NOT place anything on a battery. Otherwise, the battery may be damaged, which
may lead to fire hazards.
• The battery is heavy. Be careful when moving the battery to avoid dropping it. If the
battery is dropped and damaged, immediately leave the battery in an open area away
from people. Wait 30 minutes and soak the battery in water for 24 hours. After making
sure the power has completely run out, dispose of the battery in accordance with local
laws.
• Make sure the battery is fully charged before each flight.
• Immediately land the aircraft if a critical battery level warning appears and replace
with a fully charged battery.
• Before operating in a low-temperature environment, make sure the battery is at
least above 5° C (41° F). Ideally, above 20° C (68° F).
Using the Air-cooled Heat Sink
After flight, it is recommended to insert DB1560 Intelligent Flight Battery into the air-cooled heat
sink to charge.
1. Loosen the cable lock, then attach the charging cable to the heat sink properly.
2. Make sure the charging cable is properly secured and the cable lock is fastened, then
carefully insert the battery. DO NOT drop the battery into the heat sink.
• Only charge one battery at a time. Otherwise, heat dissipation will be affected.
• While being charged, the air-cooled heat sink will automatically start cooling according
to the temperature of the battery.
• Make sure to remove the battery charging cable when transporting. Otherwise, it will
be worn out.
• DO NOT rinse with water.
• Regularly clean the protective mesh and cooling fan to ensure good heat dissipation.
2
1
4
3
5