Publicidad
Idiomas disponibles
Idiomas disponibles
WATER DRAINAGE
The water drain hose can be positioned in
three different ways (Figure 9):
1. On the edge of a sink, using a U-hook
plastic (NOT SUPPLIED)
Make sure the hose is well fi xed on the sink.
2. Into a drainage line placed at a minimum
height of 60cm and not exceeding 90cm.
3. Direct drain into the siphon of the sink.
It is advisable to use a hose clamp (NOT
INCLUDED)
Example of installation
Figure 9
1
3
2
N.B. It is not advisable to use hose
extensions for the water drainage hose.
BEFORE USE
BEFORE USING THE
WASHING MACHINE FOR THE
FIRST TIME, IT IS NECESSARY
TO DO A WASHING CYCLE
(PROGRAM COTTON) WITH
DETERGENT AND WITHOUT
LAUNDRY, SETTING THE
TEMPERATURE AT 60 °C.
12
ELECTRICAL CONNECTION
The appliance is supplied with a
power cable and a schuko plug for
the connection to the ~ 230V 50Hz
AC grid . Make sure the schuko plug
is always accessible so that washing
machine can be disconnected from
the mains if necessary. The electrical
system must meet the provisions VDE
0100. The maximum consumption of
the washing machine is 10 Ampere.
It is strongly recommended never
to connect the appliance using
extension cables, multiple sockets
or similar devices in order to avoid
overheating and a potential fi re
hazard. The manufacturer accepts
no liability for damages resulting from
lack or interruption of the protective
earth conductor. With the purpose
of increasing the safety level, VDE
institute, by Directive DIN VDE 0100
part 739, recommends to equip the
appliance with an automatic differential
switch (circuit breaker) with trip off
current of 30mA (DIN VDE 0664).
If an automatic differential switch is
used, make sure it is of type A, in
accordance with DIN VDE 0664 and
sensitive to pulsating currents.
The identifi cation plate provides
information about the nominal power
consumption and its appropriate
protection. Please compare these data
with the data of the electrical mains.
Publicidad
