Worx WX820L.2 Manual página 13

OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
INTENDED USE:
This machine is intended for dry sanding of wood,
plastic, filler and coated surfaces. The sander is not
to be used for plaster or spackle.
ASSEMBLY AND OPERATION
ACTION
ASSEMBLY
Fitting & Replacing the Sanding
Plate
Note: Read and understand the
instructions before assembling or
changing sanding plates.
Note: Open the Hyperlock lever
completely when attaching or removing
a sanding plate.
Note: When assembling the finishing
plate/detail plate, first check the
assembling direction.
WARNING! The sanding
plate must be attached
before starting the sander.
WARNING! Avoid pinching
hands and fingers when
TM
using the Hyperlock
WARNING! Do not touch the
bottom fan after use to
avoid high-temperature burns.
Fitting the Sanding Paper
Attaching the Dust Bag
Caution:
To prevent the possibility of dust or a
foreign body being thrown into your face
or eyes, never attempt to use your sander
without the dust bag properly installed.
Charging the Battery Pack
Installing the Battery Pack
OPERATION
Switching On/Off
5-in-1 Multi Sander
FIGURE
See Fig.
A1-A8
.
See Fig.
B1-B6
See Fig.
C
See Fig.
D
See Fig. E
See Fig. F
Using the Variable Speed Dial
(Speed settings 1-6)
-The Variable Speed Dial can be used to
set the optimum speed according to the
sanding plate used and the respective
application.
Sanding
Application
paper
Sanding
down 180...400
varnishes
Sanding
40...120
paint
Touching up
120...240
paintwork
Sanding
60...240
wood
Machining
180...240
veneer
Derusting
40...120
metal
Sanding
metal and 120...240
steel
Sanding
curved 60...240
surface
Removing the Battery Pack
Emptying the Dust Bag
-For more efficient operation, empty
dust bag every 5-10 mins.
WORKING HINTS FOR YOUR
MULTI SANDER
If your power tool becomes too hot, especially when
used at low speed, set the speed to maximum and
run it with no load for 2-3 minutes to cool the motor.
Avoid prolonged usage at very low speed. Always
use sand paper that is suitable for the material you
want to sand.
Always ensure the work-piece is firmly held or
clamped to prevent movement.
Any movement of the material may affect the quality
of the sanding finish.
Start your sander before sanding and turn it off only
after you stop sanding. For the best results, sand
wood in the direction of the grain.
Do not start sanding without having the sandpaper
fitted.
Do not allow the sandpaper to wear away it will
Speed
3-6
4-6
See Fig.
1-5
G
1-6
3-5
4-6
4-6
1-6
See Fig.
H
See Fig.
I1-I2
EN
13