Descargar Imprimir esta página

LG WT4901CW Manual De Propietario página 31

Ocultar thumbs Ver también para WT4901CW:

Publicidad

Idiomas disponibles

Idiomas disponibles

Checking error messages (cont.)
Message
The display shows:
The washer has detected an out of balance
y
load.
The display shows:
If the uE rebalance (see above) is not
y
successful, this error will be displayed.
The load is too small.
y
Heavy articles are mixed with lighter items.
y
The load is out of balance.
y
The display shows:
Thermistor error
y
The display shows:
The water level sensor is not working
y
correctly.
The display shows:
Thermal overload protection circuit in the
y
motor has been tripped.
The display shows:
If an error message is displayed for
y
4 minutes, the water in the tub will
automatically drain. 'dr' will appear on the
display. You may restart the washer at this
time. However, once the washer initiates
draining, all functions will be suspended,
and 'dr' will be displayed until draining is
complete.
Possible Causes
Solutions
If the washer detects a load that is too far out of
y
balance to spin, it will display this code while it is
attempting to rebalance the load. The washer will add
water and try to redistribute the load automatically.
This display is for your information only, and no action
is required.
The automatic attempt to rebalance the load was not
y
successful. The cycle has been paused to allow the
load to be manually adjusted.
Small loads may need additional items to be added to
y
allow the washer to balance the loads.
The load may have heavy items loaded with lighter
y
items. Always try to wash articles of somewhat similar
weight to allow the washer to evenly distribute the
weight of the load for spinning.
Manually redistribute the load if articles have become
y
tangled preventing the automatic distribution from
working properly.
Unplug the washer and call for service.
y
Close the water taps, unplug the washer, and call for
y
service.
Allow the washer to stand for 30 minutes to allow the
y
motor to cool; then restart the cycle. If the LE error
code still appears, unplug the washer and call
for service.
This is normal.
y
31
TROUBLESHOOTING

Publicidad

loading