Waterpik WP112 Manual Del Usuario página 6

6
GETTING STARTED
Fill
Eject
Power
ON
High
Low
Powering the Unit
Plug the cord into an electrical outlet. If the outlet is controlled by
a wall switch, be sure it is turned on.
Preparing the Reservoir
Remove reservoir and cover from base. Fill the reservoir with
lukewarm water. Replace the reservoir over the base and press
down firmly.
Inserting and Removing Tips
Insert tip into the center of the knob at the top of the Water
Flosser handle. The colored ring will be flush with the end of the
knob if the tip is correctly locked into place. To remove tip from
the handle, press the tip eject button and pull tip from handle.
Prime Unit (First Time Use Only)
Set pressure control dial on base to high (pressure setting No.
10), point the handle and tip into sink. Turn unit ON (I) until water
flows from the tip. Turn unit OFF (O).
Adjusting the Pressure Setting
Turn the pressure control dial on the base of the unit to the
lowest setting (pressure setting No. 1) for first-time use.
Gradually increase pressure over time to the setting you prefer –
or as instructed by your dental professional.
Recommended Technique
For best results, start with the back teeth and work toward the
front teeth.
Glide tip along gumline and pause briefly between teeth.
Continue until you have cleaned the inside and outside of both
the upper and lower teeth.
Lean over sink. Direct the stream at a 90-degree angle to your
gumline with tip in mouth. Slightly close lips to avoid splashing,
but allow water to flow freely from mouth. Set pressure at
desired setting and turn the unit ON (I). Begin cleaning.
Pause Control
You can temporarily stop the flow any time by pressing the pause
button on the handle.