cecotec BOLERO HEXA Manual De Instrucciones página 79

Clean the oven interior after every use. This way, you will not cook food over this dirt.
-
- Remove lime, grease, starch, and albumen stains immediately.
Remove sugar-containing food stains immediately, if possible, while the stain is still warm.
-
Exercise extreme caution to avoid burns. Wear suitable gloves.
Use suitable roasting utensils, e.g., a roasting pan.
-
Oven door
With proper care and cleaning, your appliance will preserve its original aspect and operate
-
correctly for a long period of time.
To clean and remove the door panels, you can disassemble the oven door. The hinges of the
-
appliance door each have a locking lever.
When the locking levers are blocked, the device door is locked. It cannot be detached.
-
When the locking levers are opened to remove the door from the appliance, the hinges are
-
locked. They cannot be snapped shut. Fig. 10
Warning - Risk of injury
1. If the hinges are not blocked, they can be lock with energy. Make sure the locking levers
are always completely locked or, when detaching the device door, they are completely
unlocked.
2. The oven hinges move when opening and closing the door, be careful not to pinch your
fingers. Keep hands away from hinges.
Removing the oven door. (Fig. 11)
1. Open the door completely.
2. Open the two locking levers on the left and right.
3. Close the appliance door until it stops.
4. With both hands, hold the door from its left and right side, and pull it upwards.
Assembling the oven door
Place the device door again following the previous steps in reverse order.
1. When fixing the device door, make sure both hinges match the installation holes on the
interior front panel. Make sure the hinges are placed in the correct position. You must
be able to introduce them easily, without applying pressure. If you feel there is some
resistance, check the hinges are properly placed on the gaps.
2. Open the door completely. While you open the appliance door, you should check again if
the hinges are in the correct position. If it is installed incorrectly, then the door will not be
able to open fully.
3. Close both locking levers again.
4. Close the oven door. At the same time, check once again if the door is in the correct position,
and if the ventilation grilles are not partially sealed. Fig. 12
BOLERO HEXA SM406000 EDGE+ A+ / BOLERO HEXA SM406000 GLASS BLACK A+ / WHITE A+ / GREY A+
ENGLISH
79