cecotec BOLERO HEXA Manual De Instrucciones página 80

ENGLISH
Removing the door cover
The plastic cover layer on the door can discolour. For thorough cleaning, you can remove the
cover.
Remove the appliance door as previously indicated.
1. Press on the right and left side of the cover.
2. Remove the cover.
3. After removing the door cover, the remaining door parts can be easily removed to continue
with the cleaning. Once you finish cleaning the device door, place the cover back in its
position and press on it until it clicks into place.
4. Install the oven door and close it as indicated before. Fig. 13
Warning
While the appliance door is installed, you can also take the opportunity to remove the door
cover.
1. Removing the door cover will clear the inside glass of the appliance door; this glass can
easily move and cause damage or injury.
2. Detaching the door cover and the interior glass reduces the total weight of the door. Hinges
are easier to move when you close the door and you can get caught in them. Keep hands
away from hinges.
Due to the previous warnings, it is advisable you do not detach the door cover unless the door
is detached. The warranty does not cover damage caused by improper use.
Side guides
When you want to clean the side and interior guides, you can remove and clean them. With
proper care and cleaning, your appliance will preserve its original aspect and operate correctly
for a long period of time.
1. Pull the front of the side guides horizontally in the opposite direction until they come out.
Then you will be able to remove the guides as shown in figure 14.
2. Replace the side guides in the oven. First insert the back of the side guide into the hole in
the oven correctly, then insert the front of the element into the hole.
Attaching the telescopic guides
(Take the left side as an example to attach the guides on the right side).
1. Place points A and B (figure 15) of the telescopic guides horizontally on the outer wire.
2. Turn the telescopic guides 90 degrees counterclockwise (for the right-hand side).
3. Push the telescopic guides forward, make point C fit the lower wire and point D fit the
upper wire.
80
BOLERO HEXA SM406000 EDGE+ A+ / BOLERO HEXA SM406000 GLASS BLACK A+ / WHITE A+ / GREY A+