Items Supplied; Proper Use - EINHELL Expert TE-TS 1825/1 U Manual De Instrucciones

Anleitung_TE_TS_1825_U_SPK8_- 26.09.12 15:19 Seite 32
GB
familiar with the tool or who have not read these
instructions to use the tool. Electric tools are
dangerous if they are used by inexperienced
people.
Keep your cutting tools sharp and clean.
n
Carefully maintained cutting tools with sharp
cutting edges will jam less and are easier to
control.
If the connection lead on the electric tool is
n
damaged, it must be replaced by a specially
prepared connection lead available from our
customer service organization.
Have your tool repaired only by trained
n
personnel using only genuine spare parts. This
will ensure that you tool maintains its safety
standard.
The machine has to be set up where it can stand
n
securely.
All covers and safety devices have to be properly
n
fitted before the machine is switched on.
It must be possible for the blade to run freely.
n
When working with wood that has been
n
processed before, watch out for foreign bodies
such as nails or screws etc.
Before you actuate the On/Off switch, make sure
n
that the saw blade is correctly fitted and that the
machineʼs moving parts run smoothly.
Use clamps or a vise to hold the workpiece
n
securely. This is safer than using your hand.
Follow the instructions for lubrication and
n
changing tools.
Keep handles dry, clean and free from oil and
n
grease.
Keep the push stick or handle for a push block at
n
the machine at all times, even when you are not
using them.
Do not cut rebates or grooves without fitting a
n
suitable guard, e.g. a tunnel-type guard, over the
saw table.
Use only the transport device for transporting the
n
machine.
While you are moving the machine it is best to
n
cover the top part of the blade, for example using
a guard.
Do not lose these safety instructions.
2. Layout
1 Saw table
2 Saw blade guard
3 Push stick
4 Saw blade
5 Splitter
6 Table insert
32
7 Parallel stop
8 Handwheel
9 Adjusting and locking grip
10 Base frame
11 ON/OFF switch
12 Eccentric lever
13 Extractor hose
14 Cross stop
15 Screw with wing nut
16 Extractor adapter
20 Fixing screw
21 Clamping screws
35 Length extension table
36 Width extension table
43 Rubber feet
50 Table support

3. Items supplied

Open the packaging and take out the equipment
n
with care.
Remove the packaging material and any
n
packaging and/or transportation braces (if
available).
Check to see if all items are supplied.
n
Inspect the equipment and accessories for
n
transport damage.
If possible, please keep the packaging until the
n
end of the guarantee period.
IMPORTANT
The equipment and packaging material are not
toys. Do not let children play with plastic bags,
foils or small parts. There is a danger of
swallowing or suffocating!
Bench-type circular saw
n
Carbide-tipped saw blade
n
Parallel stop
n
Cross stop
n
Push stick
n

4. Proper use

The bench-type circular saw is designed for the
slitting and cross-cutting (only with the cross stop) of
all types of timber, commensurate with the machineʼs
size.
The machine is not to be used for cutting any type of
roundwood.
The machine is to be used only for its prescribed
purpose.
Any other use is deemed to be a case of misuse.
The user/operator and not the manufacturer will be
held liable for damage and/or injuries of any kind that