cecotec BOLERO COOLMARKET SBS 592 INOX Manual De Instrucciones página 61

When the door is high:
Open the door, use the spanner to loosen the lock nut and turn the adjustment nut clockwise to
lower the door. Once the doors are aligned, tighten the lock nut by turning it counterclockwise.
Preparing for use
Waiting time
Once the refrigerator is installed and clean, do not turn it on immediately, wait at least 2 hours
before connecting it to the power supply.
Cleaning
Check the position of the shelves and drawers in the interior of the refrigerator and clean the
interior with a soft cloth.
Switch-on
Connect the plug into a power socket to switch on the refrigerator. After two or three hours,
open the freezer compartment door: if the temperature inside the freezer compartment has
dropped, the cooling system is running normally.
Food storage
- Once the refrigerator is running, insert the food.
- When the temperature is high, food may take longer to cool down completely (try to open
the refrigerator doors as infrequently as possible).
- If the refrigerator is installed in a wet place, you must check the earth wire and the circuit
breaker are working normally. If vibration noises occur due to contact of the refrigerator
with the wall or if the wall turns black due to air convection around the compressor, keep
the refrigerator further away from the wall.
- The installation of the refrigerator may cause interference in mobile phones, landline
phones, radio receivers, or televisions near the refrigerator, so in this case, keep the
refrigerator as far away from these objects as possible.
4. OPERATION
Control panel. Fig. 6
1. Temperature decrease button
2. Freezer-compartment temperature
3. Refrigerator-compartment temperature
4. Temperature increase button
5. Temperature selection button
Bolero CoolMarket SBS 592 Inox / Bolero CoolMarket SBS 592 WD Dark E
ENGLISH
61