cecotec BOLERO COOLMARKET COMBI 322 GLASS WHITE E Manual De Instrucciones página 33

ENGLISH
1. PARTS AND COMPONENTS
Fig. 1
1. Refrigerator compartment shelves
2. Drawer cover
3. Crisper box/Humidity box
Freezer-compartment drawers
4.
5. Adjustable feet
6. Door shelves
Note:
The graphics in this manual are schematic representations and may not exactly match the
product.
2. BEFORE USE
- This appliance is packaged in a way as to protect it during transport. Take the appliance
out of its box and remove all packaging materials. You can keep the original box and other
packaging elements in a safe place. This will help you prevent product damage when
transporting it in the future. In case the original packaging is disposed of, make sure all
packaging materials are recycled accordingly.
- Make sure all parts and components are included and in good conditions. If there is any
piece missing or in bad conditions, contact the official Cecotec Technical Support Service
immediately.
Levelling
- Make sure you level your refrigerator with the front levelling feet. If it is not levelled, the
refrigerator performance will be affected, or it can even cause a malfunction.
- After installing the refrigerator, wait 4 hours before using it to allow the refrigerant to
stabilise.
B O LE R O COOLM ARKET COM BI 3 2 2 GLASS WH ITE E
64
B O LE R O COOLM ARKET COM BI 3 2 2 GLASS BL ACK E
3. INSTALLATION
Place of installation
Ventilation condition
- The location you choose for the installation of the refrigerator must be properly ventilated
and away from heat sources. Do not place the refrigerator near heat sources, like a
cooker or pot, and avoid direct sunlight to ensure the cooling effect and save on energy
consumption. Do not place the refrigerator in a damp place, to avoid rust or loss of power.
The result of dividing the total space of the room in which the refrigerator is installed by
the amount of refrigerant load in the refrigerator must not be less than 8 g/m³.
- Note: The amount of refrigerant used by the refrigerator is specified on the rating plate.
Heat dissipation space
During operation, the refrigerator releases heat into the environment. Therefore, you should
leave at least 30 mm of free space at the top, more than 100 mm on both sides, and more than
50 mm at the rear of the refrigerator. Fig. 2
Width Depth (mm) Height A (mm)
(mm) (mm)
595 635 1855 966
Note:
figure 2 only illustrates the space required for the product.
Stable surface
Place the refrigerator on a solid, flat surface (the floor) to keep it stable, otherwise vibrations
and noises will occur. When the refrigerator is placed on a carpet, straw mat, polyvinyl chloride,
solid support plates should be placed under the refrigerator to avoid colour change due to heat
dissipation.
Preparing for use
Waiting time
Once the refrigerator is properly installed and cleaned, do not switch it on immediately. Be
sure to wait at least one hour before switching the refrigerator on to ensure normal operation.
Cleaning
Check the placement of the interior accessory parts and clean the inside with a soft cloth.
B OLERO COO LMA RKET COMB I 322 G LASS W HITE E
BO LERO COOLMARKET COMBI 322 GLAS S BLACK E
ENGLISH
B (mm) C (°) E (mm) F (mm)
1202 130 50 100
65