Publicidad
Idiomas disponibles
Idiomas disponibles
4.7
CUTTING UNIT SPECIFICATION
Construction
Reel Length
Number of Knives
Front Roll
Fixed Head Height of Cut (Standard Blade)
Rear Roll
Height of Cut Adjustment
Cylinder to Bottom Blade Adjustment
Transmission
NOTE These cutting units are made to cut grass of maximum height 100 mm down to the available height of cut
range.
4.8
CUTTING PERFORMANCE _____________________________________________
71cmm (28in) width of cut:
1930 sq. m./hr. at 7.5 mph
2240 sq.yd./ hr at 12k kph
Cutting ratio:75 cuts / Metre (72 cuts/yd).
(10% allowance is included for normal overlaps and turning at the end of each cut.
4.9
RECOMMENDED LUBRICANTS _________________________________________
Grease:
For rear axle: K NATE (RJL No. 4213860), or equivalent to MIL-G-23549C, MIL-G-2345C, DIN 51 825,
DIN 51 818
All other applications: Shell Darina R2 lithium based grease or equivalent.
Engine oil:
A.P.I. Classification SJ grades. [10W-30]
4.10
ACCESSORIES ______________________________________________________
4.10.1 TRAILING SEAT KIT
A trailing seat is available.It is attached by a one pin hitch. Only use a Ransomes Jacobsen trailing seat
(LMAA747) with these machines
___________________________________________
TEMPERATURE
-15°C to 40°C
SPECIFICATIONS 4
All welded 5 knife cylinder
71cm 28in
One piece steel
3- 13mm (1/8 - 1/2in.)
2 piece cast iron bevel gear diff
Threaded Adjuster
Locknut and Screw
Centrifugal clutch and heavy roller chain
OIL VISCOSITY
SAE 5W-30
5
en-21
Publicidad
