Publicidad
Idiomas disponibles
Idiomas disponibles
INTRODUCTION 2
2.6
ASSEMBLY __________________________________________________________
The Mower is fitted to a container at the factory and will need assembly before operation. Some tools will be
needed for assembly. Discard the container according to the applicable local environmental requirement.
Remove the mower from the container. The
handles are found around the chassis - Figure
1.
The handles engage on the lug shaft (A). A
range of height adjustment is available.
Tighten the hand wheel (C) The handles
adjust for reach with the bolts (B) - Figure 2.
The Grassbox (A) - Figure 3 engages on the
mower by two lugs bolted to the chassis lug
(B).
Refer to the OPERATION Chapter before you
start the mower for the first time. Operators
MUST read through this manual and
understand the Safety Instructions, controls,
lubrication and maintenance procedures
before any use the Mower.
FIG 1
FIG 2
C
A
B
FIG 3
B
en-7
Publicidad
