Trix Big Boy 4014 Manual página 11

The extremely large locomotive places particular demands
on your model railway system. Before operating for the first
time, please check the following points in order to avoid
damage to the locomotive or your system:
• The usable minimum radius is 360 mm. However, we
recommend that you select greater radii if at all possible
(> 500 mm).
• The clearance profile of the locomotive is wider and
higher than the dimensions specified for European
model railways. Overhead cable masts and signals must
therefore be mounted as far away from the centre of the
rails as possible. Please pay attention to the signal drives,
operating levers or lanterns of the points drives which
might come into contact, depending on the installation
position. You must also take care with the tunnel entran-
ces, bridge handrails and platforms in the vicinity of the
bends in the sections.
• Points should be crossed at the appropriate speed. This
is particularly important for points with smaller radii and
for curved sets of points.
We recommend a careful test run with a second person for
assistance.
Required clearance on bends
X
Y
Radius Inside Outside
R = [mm] x = [mm] y= [mm]
360 27
437,5 26
515 25
579,3 24
643,6 23
36
34
31
29
28
11