Publicidad
Assembly
Removal and Installation
of the Blade
r !-v&vl'-_`i_ll_[ell
Disconnect plug from power source
before performing
any assembly,
adjustment
or repair to
avoid possible injury.
Note: Clean blade of any excess oil before installation.
1.
Rotate the lower guard 1 by hand. Loosen, but do not
remove, the cover
plate screw 2 using a Phillips or
straight screwdriver (Figure 2).
2.
Rotate the cover plate 3 counterclockwise
so the blade
bolt 4 is exposed (Figure 2).
3.
Press and hold the arbor lock. Use the blade wrench to
remove the blade screw by turning wrench clockwise.
NOTE: The blade screw has a left hand thread.
4.
5.
Remove the blade bolt 4, outer washer 5 and the blade 6.
Inner washer 7 does not need to be removed (Figure 3).
To install the 12" blade, fit blade between
the chip
deflectors
8 and onto the inner washer
shoulder
9
(Figure 3 & 4). NOTE: Make sure the rotation arrow on
the blade matches the clockwise rotation arrow on the
lower guard.
[l[l-I I_1
I II'!_l'vivl'-_r'l#ll#[€'ll
To avoid injury, do not use a blade
larger or smaller than 12" diameter and 1" arbor.
6.
Replace the outer washer 5 in the proper orientation,
and tighten blade bolt 4 finger tight. Press the arbor lock
and tighten blade bolt 4 securely, but do not overtighten.
7.
Rotate
cover plate 3 clockwise
to original
position.
Tighten the screw 2.
I II'!_l'vivl'-_r'l#ll#[€'ll
Never use saw without cover plate
securely in place. Lower guard will not function properly.
8.
Be sure the arbor lock is released so the blade turns
freely.
[_[_ _!
BFv_
# l-],_tl,_r=.-!
i[ ; _=VAV.=_..=.=,,==.= - After installing a new blade, lower
the blade into the table slot and check for any contact with
the base or turn table structure. If blade contacts table, seek
authorized service.
Cutting Kerr Inserts
NOTE: New inserts need to be cut initially to provide blade
clearance. This should be done by carefully making a straight
cut through the insert.
I
I
I
I
I
\
\
\
/
4
6
7
f
\
I
I
I
I
/
/
I
I
I
I
\
\
\
9
5
30
Publicidad
