Publicidad
Installation
Mounting Applications
Workbench
Mount the saw using either the four bolt holes (7/16") 1 or the
four nail holes 2 to the workbench.
Check for clearance to
the left and right of the saw (Figure 16).
1.
Each of the four mounting
holes should
be bolted
securely using 7/16" flat head screws, lock washers, and
hex nuts (not included).
2.
Locate and mark where the saw is to be mounted.
3.
Drill four (4) 7/16" diameter holes through workbench.
4.
Place the compound
miter saw on the workbench
aligning holes in base with holes drilled in workbench.
Install screws, lock washers and hex nuts.
Supporting surface where saw is to be mounted should be
examined carefully after mounting to insure that no movement
can occur during use.
if any tipping
or walking is noted,
secure
the workbench
or stand
before
operating
the
compound miter saw.
I_
i|_
Portable Mounting Using Clamps
If necessary,
clamp
the compound
miter saw to a
workbench or table top.
Place two (2) or more "C" clamps 3 on the clamping
areas and secure (Figure 17).
PortableMounting Using 2x4's
[n order to avoid any twisting of the saw, the saw can be
placed over 2x4's mounted on a workbench.
The cast-in carry handle openings have ribs on the inside
that are the same size as a 2x4.
Center the miter saw
openings
over
the 2x4 clamped
or nailed
4 on a
workbench for stability (Figure 18).
NOTE:
The board does not slide completely
through
the
opening.
The saw must be placed over two (2) boards, one
on each side.
4
46
Publicidad
