Publicidad
Saw
Operations
Crown Molding LayingFlat on Table
Follow these instructions for cutting crown molding:
1.
Move sliding fence to proper position (see Sliding Fence
on page 54).
2.
Set the bevel and miter angles using Chart 1 below.
Tighten the miter lock knob and the bevel lock handle
(Figure 33).
3.
Position molding on saw table.
Use the chart below for
correct position.
Clamp workpiece
in place using the
workpiece clamp.
IIF!'vAvl'-1E_ll_[e']l
Use clamping position that does not
interfere with operation.
Before switching
on, lower head
assembly
to make sure clamp
clears
guard
and head
assembly.
4.
Activate the switch.
Lower the head assembly and make
your cut.
5.
Wait until blade comes
to a complete
stop
before
returning head assembly to the raised position and/or
removing workpiece.
6.
ALWAYS
TAKE A TEST
CUT
USING
SCRAP
TO
CONFIRM CORRECT ANGLES.
Workpiece Clamp
33.9 ° Bevel
Crown Molding
31.6 ° Miter
CROWNMOLDING CUTS- MOLDINGPLACEDFLATONTABLE
U.S.STANDARDCROWNMOLDING
52 ° CEILING
TYPE
MITER
BEVEL
OF
(TABLE)
(TILT)
LEFTSIDE O _
RIGHT
PLACETOP
EDGE
OF 31.6° _ 33"9°
.oL_I.G
_G_.s_ _.c_-SAVE
LErr E.D O_ C UT
LEFT
RIGHTSIDEO _
31.6° @ 33"9°
PLACEBOTTOMEDGEOF
MOLDING AGAINST FENCE - SAVE LEFT END OF CUT
LEFT
LEFT S iDE 0 _ 31,6° @ 33"9°
PLACE BOTTOM EDGE OF
MOLDING AGAINST FENCE - SAVE RIGHT END OF CUT
RIGHTSIDEQ _
RIGHT
PLACETOP
EDGE
OF 31.6° _ 33"9°
.oLDI.Q
ACAI.ST
rE.CE -SAW .IO._ E .O OF C UT
Chart 1: CrownMolding Flat onTable
66
Publicidad
