Publicidad
Basic
Saw
Operations
Pipe Extension Kit with Workpiece
Support/Stop
- This
attachment 1 (accessory #80162) allows extra support for the
longer workpieces
(Figure 24).
The stops
help assist
in
repetitive
cuts.
This combines
with any length 1/2" Black
Pipe 2. Refer to the accessory instruction sheet for details.
See page 74 for a complete accessory list.
Auxiliary Fence - Certain types of molding need a fence face
extension because of the size and position of the workpiece.
Holes are provided in the fence to attach an auxiliary fence.
The auxiliary
fence
is used with the saw in the 0 ° bevel
position only.
1.
Place a piece of wood 3 against the miter saw fence
(Figure 25). (Wood can have a maximum height as
high as the fence on the left. For the right side,
check that head assembly does not interfere with
auxiliary fence.)
2.
Mark the locations of the support holes on the wood
from the back side of the fence.
3.
Drill and countersink
the holes on the front of the
support board.
4.
Attach the auxiliary fence using four (4) flat head
machine screws 4. Make a full depth cut to create
the blade slot 5. Check for interference between the
auxiliary fence and the lower blade guard.
Make
adjustments as necessary.
m'v_
II-],x,l,xr,.-]m
ir =_VAV.,_._LXL,,,L,L_ Check
for interference
from any
corn ponents.
1 (#80162)
/
\
\
\
I
I
4
Switch
Activation
To reduce the likelihood of accidental start-up, the switch is
equipped
with safety
buttons
6 that must be depressed
before the trigger 7 can be activated. The safety buttons are
designed to be activated by the right or left thumb pushing in
the left to right
direction.
When either safety
button
is
depressed,
the trigger is unlocked and it can be pulled to
activate the motor. Once the trigger is activated, release the
safety button so it can automatically
engage and lock the
switch upon release of the trigger.
Avoid positioning the palm of your
hand over the safety button.
Pressure from the palm of your
hand may unintentionally unlock the safety button or prevent
it from automatically
engaging and locking the switch upon
release of the trigger.
NOTE:
Switch
can accommodate
a padlock
with a long
shackle
of up to 1/4"
in diameter
(not provided
with
compound miter saw) to prevent unauthorized use.
4
6
5
\
\
\
\
\
3
7
52
Publicidad
