AROHA SM11R4 Manual página 5

C. Interlink the detectors
Step 1: Activate the transmit mode of 1 detector by pressing the test button 4 times within 1
second. If this is done correctly, the green LED will flash rapidly for 1 minute. Within this minute you
can connect the smoke detector to other connectable detectors.
Step 2: Press the test button of the other detector(s) twice within 1 second. This detector goes into
reception mode and the green LED light will flash slowly to confirm this. If pairing is successful,
the green LED light on the receiving smoke detector(s) will stop flashing.
Optional: Upgrade your setup with an alarm notification on your phone by
adding a WiFi interlinked smoke detector (SM11HW) to your interlinked group.
Shop now on www.invisionretail.com.
Frequently Asked Questions
Maximum interlinked detectors: 30 connectable Aroha smoke, CO and combination detectors
can be interlinked in 1 group.
Detector sounds an alarm: The test mode is activated as the test button was not pressed fast
enough. After the alarm stops, try pressing the test button again 4 times as quickly as possible
within 1 second.
Connection fails: The green LED will continue to flash for 1 minute, followed by a red LED for 2
seconds to indicate that the connection was not successful. In that case, start the pairing
process again.
Test detectors: The detectors have a transmission range of 100 meters without obstructions,
such as walls, ceilings, doors and windows. After installation, you can test whether all detectors
are properly connected to each other by pressing the test button of 1 detector; then all test
alarms from all linked detectors will also sound.
Unlinking: Press the test button on the detector twice within 1 second and the green LED will
slowly flash for 60 seconds (receiving mode). After this period, it will stop flashing and the alarm
is unlinked.
EN
04