Garland SIOUX 655 MSG Serie Manual De Instrucciones página 34

English
you have properly ventilated the area and are certain
that ventilation is sufficient so this concentration does
not happen again.
Petrol and oil are extremely flammable and
explosive under certain conditions. Do not
smoke and keep flames, sparks or heat
sources away from the machine.
Do not smoke while transporting fuel, when you fill out
the deposit or when you are working.
Do not refuel fuel in locations where there is the
presence of open flames, sparks or heat sources. Fill
the tank always in well-ventilated areas and with the
motor stopped. In the event of a fuel leak, be sure to
clean these leaks completely before starting, move the
machine away from the spillage area and avoid any
source of ignition until all vapors are gone.
Add fuel before starting the machine. Never
remove the cap of the fuel tank while the
engine is running or when the machine is hot.
Make sure the cap of the fuel is tightly and correctly
closed while you are using the machine. Make sure
to correctly and tightly close the cap on the fuel after
refilling.
Always store fuel in approved containers that comply
with the European standards.
2.5. CARE AND USE OF THIS MACHINE
Only cut grass. Do not use this machine for other
purpose not intended. For example: do not use the
lawnmower to mulch, to cut brush or bushes, and do
not use it as a mill. Using the mower for other than
the envisaged operations may result in dangerous
situations.
Use only machine accessories, tooling, etc. in
accordance with these instructions and as intended,
taking into account the working conditions and the
taking into account the working conditions and the
work to develop. The use of this mower for uses
other than the designated operations may result in
dangerous situations.
Check that all the safety devices are installed and in
good condition.
Remember that the machine operator is responsible
for the dangers and accidents caused to other people
or things. The manufacturer will not be in any way
liable for damages caused by improper or incorrect
use of this machine.
The cutting tool is very sharp. Not following the
instructions may cause severe damage.
Keep your body away from the cutting tool
while using the machine.
Do not force this machine. Use this machine to the
correct application. Using the machine for the type of
work meant to be done will allow you to work better
and more safely.
Do not use this machine if the switch does not change
between "open" and "closed". Any machine that
cannot be controlled with the switch is dangerous and
must be repaired.
Before starting work with the machine, check that the
milling tools are not in contact with any object and
that they can move freely.
Do not use the machine on steep slopes where your
safety cannot be guaranteed. If you are working on
slopes slow down your work pace and ensure you
have a good stability.
34/172