Machine Installation; Warnings; Preparation Of The Plant For Installation; Connection To The Electrical Network - Bezzera HOBBY Manual De Instrucciones

4 - MACHINE INSTALLATION

4.1 Warnings

Installation must be carried out by qualified staff,
according to the instructions supplied by the man-
ufacturer and in compliance with applicable Laws.
The machine should be located and installed in
a place where the use and maintenance are per-
formed by qualified personnel. Can be used the
machine in places used to staff kitchen areas in
shops, offices and other working enviroments;
farm houses; by clients in hotels, motels and other
residential type enviroments; bed and breakfast
type enviroments
4.2 Preparation of the plant for in-
stallation
Prepare the machine's support on a flat horizontal,
dry, smooth, sturdy, stable surface positioned at
such a height that the cup warming surface is over
150 cm from the ground.
Do not use water jets, neither perform the installa-
tion in places where water jets are used.
In order to guarantee regular operation, the device
must be installed in places where the temperature
is between +5°C and +32ºC and the humidity
does not exceed 70%.
If the machine is exposed to temperatures below +
0°C, proceed as follows:
- ensure that the machine has elapsed 24 hours
in a place where temperature is higher than +
15°C before turn it on.
The machine is electrically supplied and it needs
the following to operate:
- connection to electric network
4.2.1 Connection to the electrical net-
work
Warnings:
- The connection to the mains electricity supply
shall be executed by qualified personnel.
- The system shall be set in compliance with exist-
ing Standards and grounded.
The machine is supplied with power cable
equipped with plug; in the permanent connection
to mains electricity supply, between the machine
and the power mains, interpose a protection om-
nipolar switch, with minimum opening between
overvoltage-category III contacts, proportional to
the charge and in compliance with Standards in
force.

5 - MACHINE USE

5.1 First switching on the machine
and filling the boiler with water
The manufacturer is not liable for dam-
ages to the electrical resistance due to
failure to fill the boiler.
Do not use the machine if the drain tray is
not properly inserted in its slot.
Check periodically the cleaning and the
emptying of the drain tray.
1) Open the water tank lid (9) extract the tank (12)
(Fig. 05) fill with water.
Warnings:
Use drinking water with water hardness in French
degrees of about 15°F; never use hot water.
2) Replace the tank and insert the silicon tubes
making sure that the suction tube touches the
bottom (Fig. 06).
3) Close the lid.
4) Insert the plug in the electrical socket.
To be performed the first time or after
long periods of machine disuse and in
the event the tank is emptied:
1) Release the filter holder (21), open the water/
steam faucet by rotating the knob (5) counter-
clockwise and simultaneously press the main
switch (1) (yellow switch light on) and pump
switch (2).
2) When water flows from the steam tube (6) close
the water/steam faucet by rotating the knob (5).
Afterwards, turn off the pump switch (2); press
the coffee switch (4) (yellow switch light on) and
when the water leaves to the group press the
coffee switch (4) again (yellow switch light off).
3) Insert the filter holder (21) and wait until the
machine heats to the right temperature that is
indicated by the green light turning on (3).
When the machine is used for the first time, let
about 0.5 litres of water flow from the hot machine
to rinse the unit.
5.2 Switching on during normal op-
eration
1) Insert the plug in the electrical socket.
23
MOD. BEZZERA HOBBY