Publicidad
Idiomas disponibles
Idiomas disponibles
1.With a 4mm hex wrench
remove the 3 screws on the
protective cover on both sides
of the scooter.
4.Make sure the wheel is
aligned in the Frame and
tighten the two axle nuts with a
13mm wrench. Re-tighten the
brake arm with a Phillips
screwdriver and 8mm wrench.
Front Wheel Replacement
Tools required: Two 5mm hex wrenches.
1.Using two 5mm hex Wrenches
loosen and remove the front
axle by turning the keys to the
left.
2.Loosen the brake arm with a
Phillips screwdriver and 8mm
wrench. Using two 13mm
wrenches loosen the wheel
nuts on the rear axle.
5.Reinstall the side covers with
a 4mm Allen key. Do not over-
tighten the screws.
2.Reinstall the spare wheel
verifying the order to ensure
the location of all components.
17
3.Turn the adjusting washers
against the frame eyelash to
increase or decrease the belt
tension. The recommended belt
tension is based on being able
to bend the belt by
approximately 90 degrees.
3.Reinstall the parts and tighten
with a 5mm hex wrench in a
clockwise direction.
Publicidad
