Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
23. Attaching the Top Panel
• Locate the Top Panel (G) and align the
pre-installed screws with the screw holes on the
top edges of the main assembly.
• After inserting the screws into the holes, tighten
the fasteners from underneath the Top Panel (G)
using a Phillips screwdriver as shown.
24. Securing the Back Panels
• Place the Back Panel Brackets (NN) between the
back panels and the grooves of the assembly as
shown.
• Fasten each Back Panel Bracket (NN) using
Screws (MM). Repeat until all brackets are in
place as indicated by the diagram.
Hardware Used
Ø3x16mm
MM
Screw
Back Panel
NN
Bracket
25. Attaching the door handles
• Each door Handle (OO) has pre-attached screws.
Remove these screws and place handles over the
pre-drilled holes in the Left Door (R).
• Place the pre-attached screws on the other side of
the Left Door (R) and tighten with a Phillips
screwdriver through the door and into the handle.
• Repeat steps for the Right Door (S).
• Place the Door Bumpers (GG) on the cabinet doors
as indicated. Simply pull off the adhesive and stick.
Hardware Used
Handle with
OO
Screw
Door Bumper
GG
23MMP723REV1.0
x 14
x 14
x 2
x 2
17
23
24
25
S
R
G
Publicidad
